Loading the cartilage as well as a drum
Jimmy Sain (2022-05-03)
En respuesta a canon com/ijsetup
When you unbox the printer for the first time, there are chances that the cartilage and the drum of the printer are not pre-installed in it. So you have to do those things.
Unbox the cartilage as well as a drum from the respective boxes.
Then there is a tray in the drum where there is a space to place the cartilage in it.
Make sure the cartilage completely fits into the drum space.
Canon.com/ijsetup provides readymade cartilage with ink already placed in it.
Now put the drum with the cartilage into the drum space of the printer.
To do this open the upper cover of the printer and the shield of the printer. There you will see a space with two inclined lines.
Place the two ends over the two inclined lines and push the drum tray at an angle of 45 degrees.
The drum dray is slanted and places itself over the space.
Make sure after you place the drum a small knock sound appears. This sound confirms that the drum and the cartilage are placed well in their place.
ij.start.canon
canon pixma mg2500
Garmin Map Update
webroot.com/secure
canon ts3122 setup
ij start canon
canon pixma mg2500 install
Versión Informática de Investigación y Docencia - ISSN 1514-2469. Incluida en el Catálogo de Latindex. Licencia
Esta obra está bajo una licencia Creative Commons.